Description
Wall mounting sluice gate
CAT. (010203 )
A new developmerrt is the cast iron A.M.U.E Siuice gate Due to the design of the gate frameno recesses are needed any more in the concrete wall. The gate is mounted on the flat wall, either with anchor bolts, chemical anchors anchor rails or wall frames. The advantage of the type with flush Passage: recesses in the channel floor blocking solid matter are problem of the past .
Application
It is the best solution for waste water conduits shut off In rain water and combined sewers siphon culverts and inled structures shut - off gates are used for Direceing the combined water to the purification plant or the rain water to the main outfall .
MaterialsFrame & Door GGG40 / GG 25 Coated st. 37 / hot dip galvanized / st. St.Stem : st.se.304Stem nut : BronzeStem extension: Hot dip galvanized steel
Sealing
soft sealing ( NBR / EPDM )
Tightening Tightening achived by double inclined Bronze wedges - and double lower GG 25 locks Head stock: fabricated st 37 has desired thurst bearing.
Installation and maintenance instructions
A M.U E Sluice Gates ( Wall mounting} are fixed onto the wall as a complete unit with bearing and drive bracket and guide rails, using a chemical anchor system .on the part of the builder a planevertical/ concrete wall with dimensional tolerances in the sealing area the wall must be smooths 8and non-porous The sluice gate and the stem extension must be installed in vertical alignment.4.Before commissioning the stem z the guides and the seal should be cleaned . The stem and the stern nut should be greased with a water- repelling lubricant
Operation
Manually: by handwheel / or electrically by electric actuator ( under Request )
How it would be requested ?To select the proportional Design of the wall mounting gate we need the dimension of :- Duct width (mm} X up to 2500 for C.I without limits for st. St. Or st. 37- Duct height (mm) y up to 2500 for C.I without limits for st. St. Or st. 37- Plat form height (mm) *y l for spindle lengthY1 > y + 400Otherwise the gate will be closed frame without Headstock . - Min. Openning X1 for installation on the site - Max pressure behinde the gate